Apr 12, 2025 Leave a message

Daily maintenance of airflow crusher

Airflow crushers are widely used in industries such as chemical, pharmaceutical, and new energy due to their pollution-free advantages. The airflow crusher is a device that uses air separation, heavy pressure grinding, and shearing to achieve ultrafine crushing of dry materials. Based on the adhesive properties of petroleum coke powder, the structural design of the grinder and classifier has been optimized, effectively solving the problem of adhesive and improving the production without large particles.

 

Daily maintenance of the airflow pulverizer requires checking the power socket, plug, and power cord for any signs of oxidation, detachment, or breakage. If not, the machine can be tested by plugging in the power source. When the motor is powered on and does not rotate, and the wheel can be gently turned by hand, it can be concluded that one of the two starting capacitors of the machine has failed in capacity. If discharge sparks can be emitted and there is a loud popping sound at this time, it indicates that the capacitor can use; If the spark and sound are weak, it indicates that the capacitance of the capacitor has decreased and needs to be replaced or an additional small capacitor needs to be added. If the capacitor of the airflow crusher is damaged and short circuited, this method cannot be used, and it can be repaired by replacing it with a new product of the same specification.

 

1. Check if the lubrication of the bearings is good and if all fasteners are tightened.

2. Check for any materials or other debris inside the damaged cavity, and if necessary, clean it thoroughly.

3. Check whether the protective device is in good condition. If any unsafe phenomena are found in the protective device, they should be eliminated in a timely manner.

4. Check if the hydraulic jacking machine head or jacking screw is retracted, adjust if the gasket is installed correctly and tightened.

5. During operation, check the compressed air pipeline for air leakage at least once per shift, and drain the accumulated water in the oil-water separation triple component once.

6. Check the discharge door once a week for any material leakage, damaged sealing strips, and whether the discharge linkage mechanism is in the dead center position when closing the door.

7. Check whether the transmission belt is installed correctly and in good condition. If the belt is found to be damaged, it should be replaced in a timely manner. When there is oil stains on the belt or pulley, a clean cloth should be used to wipe it clean in a timely manner.

 

Send Inquiry

Home

Phone

E-mail

Inquiry