The cleanliness level of the airflow crusher is an important indicator in the crushing operation, because the airflow crusher is in direct contact with the material, so the cleanliness level of the airflow crusher is very important, which directly affects the quality of the material. After use, it is necessary to clean it carefully, in order to make it more convenient for the next use and avoid affecting the quality of the material. Below are a few methods for cleaning a shredder.
1. After the production of the airflow crusher is completed, turn off the power and send all materials in production to the intermediate station according to the material entry and exit procedures. Hang the device to be cleaned status sign.
2. Open the chemical crusher and move the cylinder, grading wheel, detachable air duct, etc. into the cleaning room sink. Inject about 2/3 volume of 30-40 ℃ warm water into the sink, soak for 10-30 minutes, and then wash the front and back of the powder bag repeatedly with running water until the bag is clean;
3. Dip a clean specialized cloth into warm water and repeatedly wipe the material inlet, inner chamber, material outlet, and powder collection room of the crusher until they are clean.
4. Wash the grading wheel and air duct with a soft bristled brush until the water becomes clear, and rinse three times with ionized water. Dry in a clean area of the same level as the crushing room and set aside for later use.
5. Thoroughly wipe and clean the inner wall, powder conveying pipe, and cyclone separator of the chemical crusher with deionized water.
6. Wipe the above parts dry with a clean dry towel, and then wipe clean with 75% ethanol.
7. Wipe the floor of the operation room, distribution cabinet, motor, and operation cabinet clean. After the cloth bag and filter are dried, clean and rinse the floor of the operation room on time until there is no dust or water accumulation on the ground




