May 16, 2025 Leave a message

Energy Consumption Analysis Of Blow Molding Machine

Energy consumption composition
The energy-saving of blow molding machines is mainly divided into two parts: power and heating, which also correspond to the main components of energy consumption of blow molding machines.

 

Power section
The power part mostly relies on motor drive, and traditional motor operation may have high energy consumption problems. For example, the actual power of the motor is 50Hz, but in production, only 30Hz is needed, and the excess energy consumption will be wasted.

 

Heating section
The traditional heating method for the heating part uses resistance coil heating, which has problems such as low thermal energy utilization, high heat transfer loss, and slow heating speed, resulting in high energy consumption.

 

Energy saving measures and their effects
Energy saving in the power section
Most of them use frequency converters to save energy, by changing the power output of the motor, saving the residual energy consumption of the motor. If the actual operating frequency of the motor is adjusted from 50Hz to 30Hz required for production, energy-saving effect can be achieved.

 

Energy saving heating section
The heating part often uses electromagnetic heaters, which have significant energy-saving effects compared to old-fashioned resistor coils, with an energy-saving rate of about 30% -70%. The reasons are as follows: 

Adding insulation layer: Compared to resistance heating, electromagnetic heaters have an additional insulation layer, which improves the utilization rate of thermal energy.
Reduce heat transfer loss: The electromagnetic heater directly acts on the material tube for heating, reducing the heat loss during the heat transfer process.
Accelerate heating speed: Heating speed is more than a quarter faster than resistance heating, reducing heating time.
Improve production efficiency: Fast heating speed increases production efficiency, keeps the motor in a saturated state, and reduces energy loss caused by high power and low demand.
The impact on enterprise costs and environmental protection


In terms of cost
After adopting energy-saving measures, the energy consumption of blow molding machines is reduced, which can effectively reduce the energy cost expenditure of enterprises and improve their economic benefits. For example, using a frequency converter in the power section can save energy and reduce excess energy consumption of the motor; The heating part adopts electromagnetic heaters for energy saving, which can reduce energy consumption by 30% -70% and save a lot of money in the long run.

 

In terms of environmental protection
Reducing energy consumption means reducing energy consumption, indirectly reducing pollutant emissions caused by energy production, which has a positive impact on environmental protection and meets the requirements of sustainable development.

 

Send Inquiry

Home

Phone

E-mail

Inquiry