Regular maintenance is necessary to extend the service life of plastic blow molding machines. The following are detailed maintenance points:
Maintenance before startup
Lubrication operation
Before starting the plastic blow molding machine in each shift, lubricating oil must be added to all moving parts, such as the robotic arm, robotic arm guide rail, and mold opening and closing guide rail; The swing arm can be lubricated once every 3-4 days, and the large and small chains of the heating machine can be lubricated once a month. At the same time, the main engine reducer and heating machine reducer should be checked regularly for oil shortage. The main engine bearings can be lubricated once every 2-3 months.
Component inspection
Mechanical structure: Before formal operation, check whether the moving parts are sturdy, whether the screws are loose or loose, especially in areas with strong impact, and whether the belt transmission part is abnormal; At the same time, check that there are no people or foreign objects inside the machine, especially the handle position, to avoid injury.
Pneumatic components: Check whether each pneumatic component can leak air and whether the action is flexible; Check if there is any abnormal air leakage or blockage in the triple unit, and if the water storage capacity in the cup is too full.
Electrical system: Check if all emergency stop switches, safety door switches, and protection device detection switches are functioning properly; Check if the lamp tube is damaged or broken, and replace it in a timely manner.
Air source inspection: Check whether the high-pressure air source, low-pressure air source, power supply, and water source are normal; When opening the up and down pressure air source switch, it must act slowly to prevent the air source flow rate from being too fast and causing dirt to blow into the solenoid valve. At the same time, open the exhaust valve for 30 seconds to ensure clean air.
Heating section: Check if the heating head enters the embryo and if the embryo dropping section works properly. If the embryo insertion is not in place, adjust the screw of the embryo pressing device; Before starting the heater, make sure that the cooling water is turned on. After starting the motor, delay starting the heater for 30 seconds to prevent voltage fluctuations; After starting the heating process for 2-3 minutes, wait for the oven temperature to rise evenly before pressing the embryo button. At the same time, turn on the blowing bottle and power it on.
Maintenance and upkeep during operation
Product quality monitoring: After the plastic blow molding machine is working normally, the operator must regularly check the quality of the bottles to avoid voltage fluctuations or other reasons affecting the quality of the blown bottles.
Equipment status observation: When the machine is running, close attention must be paid to whether there is any abnormal noise. Early detection, timely shutdown, and early resolution should be achieved; In case of emergency, you can press the emergency stop button, apply the emergency brake, and then analyze the cause based on the on-site situation to quickly solve the problem.
Hydraulic system maintenance: Before changing the oil, drain the original hydraulic oil, check the return filter element, suction filter element, and pilot filter element to see if there are iron, copper, or other impurities attached. If there are any, there may be hydraulic component faults. After troubleshooting, clean the system.
Electromagnetic valve cleaning: When the electromagnetic valve of the bottle blowing machine encounters abnormalities, it should be cleaned in a timely manner (once every 3.5 million bottles blown).
Mold maintenance: The blow molding mold must be cleaned and polished regularly.
Regular deep maintenance and upkeep
Filter inspection: If smoke starts to appear after a few days to two months of use after maintenance, it is considered that there is a problem with the filter. Under normal circumstances, the service life of the filter should be 2000 hours or more than three months. If smoke appears before this time, it is either due to a quality issue with the filter or a problem with the vacuum pump oil.
System comprehensive maintenance: Regularly conduct comprehensive maintenance on various systems of the blow molding machine, including mechanical system, pneumatic system, hydraulic system, electrical system, etc., to promptly identify and solve potential problems, ensuring the long-term stable operation of the equipment.




