Jul 26, 2025 Leave a message

Common problems and solutions for hollow blow molding products

Hollow blow molding technology is one of the common technologies for plastic processing. Hollow blow molding products are widely used in various industries, containers, beverage bottles.

 

This article will summarize the quality problems that may occur in hollow blow molding products and briefly explain the solutions for discussion.

 

1. Large fluctuations in product weight

Reasons:
Sudden changes in the parison;
Uneven mixing of raw materials;
Blocking or bridging of the feed section, resulting in unstable extrusion; Hollow blow molding products
Unstable extruder speed.

 

Method:
Check and repair the wall thickness control device to make the parison control more stable;
Use a suitable material mixing device and appropriately extend the mixing time to mix the raw materials evenly;
Check whether there is any blockage or other foreign matter blocking the water inlet;
Appropriately reduce the air inlet temperature to avoid the "bridge" phenomenon;
Check whether the extruder motor is abnormal, whether the motor and gearbox are loose or slipping, and ensure that the screw speed is stable;
At the same time, we also need to check the electronic scale regularly to avoid the fluctuation of the measuring instrument affecting the quality judgment;

 

2. Insufficient capacity

Reason:
The shrinkage rate of raw materials of different brands will be different, and the mold cooling temperature and blow molding setting time are the reasons for excessive shrinkage and shrinkage of the product.
We need to analyze and solve the problem in a targeted manner to keep the shrinkage rate of the product within a controllable range;
In addition, the wall thickness of the product is too thick or uneven, causing deformation, concave sagging. The appearance of the product does not meet the design expectations and the volume does not meet the standards.

 

Methods:
Repair and improve the mold to meet the theoretical volume requirements first;
Replace raw materials with smaller shrinkage, extend the blow molding time, reduce the mold cooling temperature, and minimize the shrinkage of the finished product;
Adjust the wall thickness controller to make the wall thickness evenly distributed and solve the problem of individual parts being sunken and deformed;
Appropriately adjust the blowing time to make the product shape meet the original design intention;
Or solve the problem by appropriately increasing the blow molding pressure.

Send Inquiry

Home

Phone

E-mail

Inquiry