Apr 04, 2025 Leave a message

Common causes of material pipe blockage in blow molding machines

Agglomeration of rubber material: Agglomeration of rubber material may occur in the throat of the feeding cylinder. This is because if the temperature of the cooling water jacket at the throat of the feeding cylinder is not below 40-60 ℃, it may cause the rubber material to clump and block the feeding tube.

 

Filter blockage: After a period of use, the filter will be blocked by impurities, which will affect the normal flow of raw materials and cause blockage of the material pipe. At this time, a new filter needs to be replaced.

 

Adhesive sticking in the screw feeding section: If the temperature is not appropriately lowered before shutdown, there may be adhesive residue and sticking in the screw feeding section. After startup, these adhesive sticking will affect subsequent feeding and cause blockage of the material pipe. If this phenomenon is found after turning on the machine and cleaning the screw is inconvenient, using a plastic or wooden stick to squeeze the material at the feeding port may further exacerbate the risk of blockage due to the falling of wood chips.

 

Equipment operating parameter issues

Abnormal temperature: If the startup temperature is too low, the temperature of the extrusion tube, connecting tool, and die head may not meet the standard, or if the external temperature meets the standard but the heating time is not sufficient, resulting in inconsistent internal and external temperatures, it may cause the rubber material to not flow normally and cause blockage of the material pipe. In addition, unstable temperature of the extrusion tube or die head can also affect the flowability of the rubber material and cause blockage.

 

Back pressure problem: Too low back pressure can cause unstable discharge, which may lead to the accumulation of raw materials in the material pipe and ultimately cause blockage. This phenomenon can be corrected by increasing back pressure.

 

Mechanical component issues

Transmission belt problem: Loose or detached transmission belts can affect the normal rotation of the screw, leading to poor feeding and blockage of the material pipe. Old and unusable drive belts need to be replaced, while those that are still usable should be equipped with an idler to adjust the belt tension.

 

Roller clamping problem: Uneven roller speed or excessive pressure between rollers may cause problems during the raw material conveying process, affecting the smoothness of feeding and leading to blockage of the material pipe. It is necessary to check whether the clamping roller is eccentric, whether the transmission belt is worn or loose, and adjust the pressure between the rollers.

 

Other issues

Voltage fluctuation of DC motor: Excessive voltage fluctuation of DC motor can affect the stable operation of equipment, leading to unstable feeding. It can be ensured that the voltage is stable by installing a voltage stabilizer to prevent material pipe blockage caused by voltage problems.

 

Send Inquiry

Home

Phone

E-mail

Inquiry